The Mission: Simple slip, Big effect
To give life to vision in my brain, the girls’ Easter dresses needed some serious poof-age.
For little Gladys’, I built netting right into the dress, but I wanted Gianna’s to be more versatile. (Think easier laundering, ability to wear petticoat under multiple dresses, etc…)
And for you, a tutorial.
- pre-made knit camisole
- lining fabric (approx. 1 yard)
- soft netting (approx. 4 yards)
- thread, marking pen, pins, etc, etc..
Step 1: Make Bodice and Skirt of Petticoat
Cut off the waist of the camisole to match the length of the dress’ bodice from shoulder to waistline (plus seam allowance).
Cut out a rectangle of the lining fabric for the petticoat’s slip. The length of the rectangle is equal to the desired skirt length, plus hem and upper seam allowance. We will be using the full width across the lining fabric (from selvage to selvage) for the skirt width.
For example, I wanted Gianna’s slip to have a 13 1/2 inch skirt when done, with a 2 inch hem on the bottom and a 1/2 inches seam at the top (plus an extra inch for finishing the top edge*). Meaning, I cut a piece 16 inches long and 60 inches wide.
Finish the top edge of the skirt (overlock, zig-zag, whatever), and hem the skirt bottom. I know, I know. Usually hemming is the last step, but it will be easier now without the netting, and this will be worn under a dress and no one will notice.
*This lining stuff frays like crazy. So, instead of overlocking, I hemmed the top edge to keep it from fraying. This is not necessary for other fabrics.
Step 2: Prepare Skirt Netting
Using a removable marking pen, mark a line 2 inches and 6 inches from the skirts top edge. This is where we will attach the netting.
For each of the marked lines, cut a piece of netting with a length twice the distance from the line to the bottom hem long and a width 2 to 3 times the width of the skirt piece.
For Gianna’s skirt, this meant to one piece of netting was 23 inches long (2 x 11.5) and the other was 15 inches long (2 x 7.5).
I used the full 4 yards (144 inches) of netting I had available for the width. Gianna’s skirt piece is 60″ wide, so I needed somewhere between 120 – 180″.
In summary, one piece of netting was 23″ by 144″ and the other was 15″ by 144″.
Step 4: Gather netting and sew to skirt along placement lines.
Fold the shorter of the two pieces of netting in half width-wise (fold parallel to long edges) . Baste the long unfolded edges together, and then pull on the bobbin thread to gather it down to the skirts width. Pin in place along lower placement line and sew with a zig-zag stitch.
Repeat to sew a second layer of netting along the upper placement line.
Step 5: Sew the Skirt’s Side Seam
Fold the skirt in half lengthwise (fold parallel to short edges), netting inside. Sew the short ends together, keeping the netting out of the way as much as possible. Turn right side out. Now we are ready to put the cut-off cami and skirt together!
Step 6: Sew Skirt to Cami Top
Gather the top edge of the skirt with basting stitches. Pin it to the bottom of the cami right sides facing. Sew together with a stretchable stitch (either an actual “Stretch Stitch”, or a slight zig-zag). Remove basting stitches, and you’re done!
Did you enjoy this tutorial?
Find more tutorials and patterns here.